Owner's Manual

This is what your Forge looks like when it arrives!

We carefully protect your Forge prior to shipment. All sides are marked clearly to ensure it is fully protected during the journey!

We recommend having a second set of hands nearby to help you move it to your desired location. 

Indoors or Outdoors?

You can keep your Forge indoors or outdoors. If you decide to keep it outdoors, we recommend keeping it under a patio cover for optimal protection and performance. 

*When filling, leave about 6 inches from the top to keep from overflowing when entering, as shown to the left.*

When using an indoor Forge, we like to use a water tray to help keep the floor dry!

Cold Forge Accessory Kit

Cold Forge Kit includes: submersible pump and hose

You will use this kit when draining your Forge for cleaning. Attach the hose to the pump and place it on the bottom of the tub. The pump has suction feet to attach to the tub. Plug in, and drain!

We recommend draining to clean 1-2 times per month. You can wipe the inside of the tub with a microfiber towel.

Filtered Forge Accessory Kit

Filtered Forge Kit includes: Hose with adapters, inlet strainer (microphone device), and additional hose adapter

The inlet strainer is attached to the inside of the tub where the water enters the filtration system. 

The other hose adapter is attached to the inside of the tub where the bubbles come out of the filtration.

The silver button on the left is your Air Switch. You will press this button to turn your filtration system on and off. For commercial facilities it will remain on 24/7.

You can use the hose on the inlet side to vacuum debris from your Forge. You can attach it to the outlet side to drain the Forge if needed. 

You will clean your inlet strainer post plunge, just like you would clean your drier filter after each use. You can wipe the inside of the tub once per week with a microfiber towel.

We recommend draining and cleaning 1-2 times per year. 

Accessory Kit

Air Switch

Additional Accessories

Your Forge will also come with an InkBird temperature controller. 

The number on top is the temperature of the water in your Forge. The bottom number is the set temperature. 

You will hold the "Set" button until it starts blinking to change your set temperature, and then hold it again to complete setting. 

Your Filtered Forge  is backed by a full 2 year warranty. 

 

For questions and comments:

info@morozkoforge.com 

(602)456-6338

Thank you,

Morozko Forge

Maintenance

Maintaining your Stainless Forge is easy! 

You will clean off your inlet strainer after each use, just like you would for your dryer filter. We also recommend wiping down the inside of the tub 1-2 times per week with a microfiber towel. 

You will replace the water on your Filtered Forge 1-2 times per year or as needed based on the water quality. 

You will attach your hose to the outlet side, where your filtration bubbles appear. Turn the filtration on and it pumps the water out for you. 

info@morozkoforge.com

602-456-6338
Phoenix Arizona, USA

  • YouTube
  • Instagram
  • Twitter

© 2019 by Morozko Forge, LLC. 

Privacy Policy